MPEG LA 8CH Manual do Utilizador descarregar pdf (Página 9)

CONNECTION AND SETUP

3. CONNECTION AND SETUP

3.1. HDD Installation

The HDD must be installed before the DVR is turned on. The steps below are for your reference only. The actual

installation process may vary depending on different models and situations.

Step 1: Loose the screws on the upper cover and open the upper cover of the DVR.

Note: The DVR cover is made of metal. Please be careful with its edge when you remove the cover.

Step 2: Remove the HDD bracket.

Step 3: Get a compatible HDD, and connect it to the power connector and data bus connector with the PCB side

facing up.

Note: Make sure the HDD power cable is connected to the WHITE jack on the DVR mainboard as shown

below. The brown jack is reserved for DVD writer installation for Model 5 & 7.

Step 4: Fix the HDD to the bracket with the PCB side facing up, and replace the HDD bracket back to the DVR

base.

Step 5: Close the upper cover of the DVR, and fasten all the screws you loosened in Step 1.

Note: When a HDD is connected for the first time and the DVR is turned on, the DVR will automatically

detect & format the HDD as needed. At the same time, the DVR will also scan the HDD for any bad

sector, and use the good ones for recording and data storage.

It takes about eight minutes for a 1TB HDD to finish the whole process, and the actual time needed

varies based on different HDD capacity.

3.2. Camera Connection

The cameras must be connected and power-supplied. And then connect the camera video output to the DVR

video input port with a coaxial cable or RCA lines with BNC connectors. The DVR will automatically detect the

video system of the connected camera(s) (NTSC / PAL), and switch itself to the correct system.

1) Power connection

Connect the camera with indicated power supply.

2) Video cable connection

Connect the camera video output to the DVR video input port with a coaxial cable or RCA line with BNC

connector.

3) Audio cable connection

Connect the camera audio output to the DVR audio input port with a coaxial cable or RCA line with BNC

connector.

4) Camera Setup (PTZ cameras only)

For detailed camera title, ID, protocol and baud rate setup, please refer to “5.5. REMOTE” at page 15.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 44 45

Sem comentários

MPEG LA 8CH Manual do Utilizador Página 9